Bosch ME17.8.8 Module

Caption: 

• RD: Read
• VR: Vitual Reading
• WR: Write
• CS: Checksums and CVN correction
• R: Recovery
• UNLOCK: Unlock ECU

Software module for editing calibrations Bosch ME17.8.8 and Bosch ME17.8.8.1 ECUs of petrol normal aspirated and turbocharged vehicles from China market.

Supported maps:

• Air control: airmass flow through throttle valve, throttle valve position, accelerator pedal map
• Boost: wastegate duty cycle target/linerisation, P-controller, regulation basis, boost limitations
• Exhaust gas temperature
• Idle: desired idle speed AT/MT, desired idle speed with A/C, minimal idle speed
• Knock control: knock sensor sensetivity per cyliner, retardation step, retardation recovery
• Limiters: engine speed limitation
• Spark advance: base spark advance, minimal spark advance, optimal spark advance, spark advance correction from almbda
• Switch operation modes: requested torque threshold to enter full load, throttle position for full load detection
• Target lambda: target lambda at part load, full load, acceleration, warm up, delay before entering acceleration, delta correction
• Torque limitation: monitoring torque limitation, offset tolerance for allowed torque, maximal torque
• Torque model: driver requested torque, optimal indicated torque, target air filling from torque, ignition angle efficiency, indicated torque limitation, lambda efficiency, minimal efficiency
• VVT: intake camshaft position
• Fan control: switching on/off coolant
• Injector control: injection end timing
• DTC mask editor (if missed – need to order mappack update)

Supported SW list

ECUTools Vietnam

Whatsapp: +84.899.402.402

Facebook: ECUTools.vn

Youtube: ECUToolsvn

Tiktok: ECUTools

Website: ECUTools.vn