Bosch EDC17CP02 Module

Caption: 

• RD: Read
• VR: Vitual Reading
• WR: Write
• CS: Checksums and CVN correction
• R: Recovery
• UNLOCK: Unlock ECU

Software module for editing calibrations Bosch EDC17CP02 ECUs of diesel BMW vehicles.

Supported file size 1.46 Mb.

Available maps:

• Airmass: desired airmass flow with enabled and disabled EGR, maximal airmass flow, airmass correction
  
• Boost control: boost controller duty cycle base, in regeneration, in double injection mode, with disabled EGR, maximal boost controller duty cycle
  
• Boost pressure: boost pressure limitation, desired boost pressure base, in regeneration, in double injection mode, with disabled EGR, with closed bypass
  
• DPF: Enable switches for DPF, regeneration lookup mask, exhaust sensor scaling and check conditions
  
• EGR control: thresholds for enable/disable EGR
  
• EGT Sensors: EGT sensors scalings, switches and check conditions
  
• Injection: injection quantity from torque conversion maps, injector opening time, post injection quantity
  
• Rail pressure: Rail pressure base, at idle, rail pressure limiters, P, I components for flow regulator, injection flow regulator map, rail pressure regulator maps
  
• Start: engine speed after start, start torque, minimal engine speed
  
• Start of injection: base start of injection angle for main injection, time component between Pi1 and Pi2
  
• Target lambda for smoke limitation
  
• Torque limitation: torque limitation inner/outer torque, powertrain torque, conditional torque limitation from EGT, exhaust pressure, fuel temperature, torque limitation in system errors.
  
• Torque monitoring: torque limitation in monitoring mode, accelerator pedal for monitoring
  
• Requested torque: requested torque from accelerator pedal base, requested torque correction factors from coolant and atmospheric pressure
  
• DTC editor

Supported SW list

ECUTools Vietnam

Whatsapp: +84.899.402.402

Facebook: ECUTools.vn

Youtube: ECUToolsvn

Tiktok: ECUTools

Website: ECUTools.vn